UHF TV Antenna P-41-7 TRIPLEX
YAGI UHF TRIPLEX antenna with excellent gain, suitable for receiving weak TV signals.
The antenna features improved gain and 4G/5G noise protection achieved through mechanical redesign.
Antenna P-41-7 TRIPLEX CF
- Antenna can be mounted on a mast in horizontal or vertical polarization
- Covering the UHF band
- The antenna is especially designed for the digital terrestrial signal's (DVB-T) reception
- Enhanced gain and 4G / 5G noise protection achieved through mechanical redesign
- Optional embeddable electronic filter (active or passive) for superior gain and/or sharper 700/800 MHz noise reduction
- Dipole: DTX dipole with different baluns and with "F" female connector
- Central antenna carrier: 18x18 mm
- Side antenna carriers: 14x14 m
- Reflectors:
- Grid reflector - grid made by iron bars, powder-coated
- Tube reflector - main reflector carrier 18x18 mm, seven tubes with outside diameter 8 mm
- Antenna has all three antenna carriers pre-assembled. Two side antenna carriers must just be opened and fixed with plastics and screws
Passive antennas
- P-41-7 TRIPLEX MF: Basic antenna with »F« female connector and grid reflector
- P-41-7 TRIPLEX CF: Basic antenna with »F« female connector and tube reflector
- P-41-7 TRIPLEX MLT7: Antenna with YAGI LTE 700/800 LIGHT filter, grid reflector and »F« female connector
- P-41-7 TRIPLEX CLT7: Antenna with YAGI LTE 700/800 LIGHT filter, tube reflector and »F« female connector
Active antennas with low-noise amplifier
- P-41-7 TRIPLEX MG: Antenna with amplifier DIGI-YAGI 18U, grid reflector and »F« female connector
- P-41-7 TRIPLEX CG: Antenna with amplifier DIGI-YAGI 18U, tube reflector and »F« female connector
- P-41-7 TRIPLEX MGLT7: Antenna with active YAGI filter DIGI-YAGI 18U L7 (amplifier DIGI-YAGI 18U and YAGI LTE 700/800 LIGHT filter), grid reflector and »F« female connector
- P-41-7 TRIPLEX CGLT7: Antenna with active YAGI filter DIGI-YAGI 18U L7 (amplifier DIGI-YAGI 18U and YAGI LTE 700/800 LIGHT filter), tube reflector and »F« female connector
YAGI LTE filters (passive components), amplifiers DIGI-YAGI (active components) or Active YAGI LTE filter (active components) are made as single balun. They can be installed only into YAGI antennas with DTX dipole (into all DTX, DTM, TRIPLEX and UF antennas).
They have »F« female connector and can be used for upgrading existing antenna too. For replacing balun (upgrading) the tools are required.
Antenna with built-in amplifier DIGI-YAGI or Active YAGI LTE filter is receiving signals only if amplifier is power supplied. It can be supplied from outside power supply of directly from DVB-T receiver. Power supply is provided through the same coax. cable as reception signal.
Amplifier DIGI-YAGI 18U:
Frequency range: UHF Ch. 21-69 (470-862 MHz)
Amplification: 18 dB @ 5-24 VDC
P-P: 1,4 dB
Noise figure: 2 dB
Max. output level: 96 dBμV
Power supply: 25 mA @ 5-24 VDC
Connector: »F« female
YAGI LTE 700/800 LIGHT filter:
Filter passes all frequencies from 0 to 697 MHz (up to Ch.48) and primary cuts signals above 697 MHz (above Ch. 48).
Average attenuation of LTE 4G frequencies from 698 to 862 MHz (Ch. 49-69) is -20 dB.
Active YAGI LTE filter DIGI-YAGI 18U L7:
It is a single balun with combined amplifier DIGI-YAGI 18U and YAGI LTE 700/800 LIGHT filter.
- Channel (freq.): UHF Ch. 21-48 (470-694 MHz)
- No. of elements: 41
- Gain: 11,5-16 dB(i)
- F/B ratio: with grid reflector 28 dB / with tube reflector 27 dB
- Beam width: Horizontal 32° ; Vertical 35°
- Antenna length: 118 cm
- Inclination: 0°-10°
- Mounting on mast with outside diameter: 20-62 mm
-
Contact Sales
Marko Macek
E-mail Contact card -
Technical Documentation
Iskra antenna system catalog PDF 10,492 kB -
Certificates